NEWS
Wuxi Simply Electronic Technology Co., Ltd

NEWS

Company News

Industry News

Technical Communication

Download

What aspects should be paid attention to in the design of LED driver power PCB board?

What aspects should be paid attention to in the design of LED driver power PCB board?

Establish component parameters from schematic diagram to PCB design process - Input principle network table - Design parameter settings - Manual layout - Manual wiring - Verify design - Review - CAM output.

27

2023

/

04

Discussion on the Development Trend of Intelligent Lock Circuit Board in the Future

Discussion on the Development Trend of Intelligent Lock Circuit Board in the Future

Introduction to the Development of Smart Locks in China: Guangdong and Zhejiang are the regions with good development, while Shanghai is the region with poor development. Some large factories are either losing money or on the brink of losing money.

27

2023

/

04

A method for quickly detecting PCB board faults

A method for quickly detecting PCB board faults

Making an FC8 board is not simply a matter of following the process to complete the board. Just drill a hole and add a component. The production of PC8 board is not difficult, but the difficulty lies in troubleshooting after completion. Whether it's a personal enthusiast or an industry engineer, encountering problems while debugging PCB circuit boards is also quite a headache, just like programmers encountering bugs.

27

2023

/

04

Soft and hard combination circuit board! Reasons and countermeasures for PCB board delamination

Soft and hard combination circuit board! Reasons and countermeasures for PCB board delamination

PCB board layering refers to the phenomenon where the surface layer and bottom layer of a PCB board are separated during the manufacturing process due to factors such as material, process, and environment. The following are the main reasons and countermeasures for PCB board layering:

27

2023

/

04

How to deal with PCB solder pads that have been soldered off! Security monitoring circuit board

How to deal with PCB solder pads that have been soldered off! Security monitoring circuit board

When soldering a circuit board, the solder pads often fall off due to prolonged soldering time or excessive temperature caused by repeated soldering. The copper plates on the solder pads of the circuit board expand repeatedly before falling off. It is important to pay more attention to this during soldering to prevent further detachment.

27

2023

/

04

< 12 >